Installation steps:
1. First determine the position of the main and auxiliary columns with appropriate distance, deal with the placement mode and position of each wiring, and then fix the main column (expansion screw φ 12/10）。 Note: there are two wires at the bottom of the main column, one is rvv2 * 1.0 DC24V power supply (to the distribution box) and the other is rvv4 * 0.5 (to the access control direction). The wiring will be different depending on the access control installation mode on site
2. Install the light sensing receiver and lead the wiring of the light sensing receiver to the top of the main column.
3. When installing the door body, first lead the wiring between the magnetic lock and the light bar from the inside of the main column to the top of the main column through the bearing circular hole at the bottom of the main column; The circular groove of the door body is aligned with the bearing,
4. Install the motor mounting plate, align the circular groove on the upper part of the door body with the bearing, and fix the motor mounting plate on the main column with screws,
5. Fix the motor and fix the motor on the mounting plate with screws,
6. Fix the auxiliary column and align the magnetic lock. (at this time, push the door body by hand to check whether the door is opened and closed normally and whether there is abnormal noise. If there is any abnormality, please check steps 4 and 5)
7, control the wiring diagram of the main board to connect the corresponding line, then debug the advertising door. After the parameters are adjusted, the motherboard is placed in the corresponding position, and the lid is used normally.
